2015-2017 Mustang Angled A/C Vent Mount for 60mm EBoost2 Instructions

Installation of S550 Mustang EBoost2 Mount

Step 1: Carefully remove dash trim panel from dash. Clips can easily be damaged.  Videos can be found online to properly remove without damaging the panel.

Step 2: Remove ac vent from dash trim panel by pressing the four chrome tabs that are holding it in the panel. 

Step 3: Place the rear plate that holds the Boost2 into the backside of the dash trim panel where the ac vent used to sit. Hold plate in place.

Step 4: With rear plate held in place, install the front ring with both bolts lined up to the bolt holes. Be sure front ring is installed in the same orientation that it was shipped.  Make sure ridges around the bolts are facing the rear plate. Place lock washers and nuts on the back of the bolts. Gently tighten nuts so the mount will still turn in the trim panel.  

Step 5: The mount can be turned for desired angle. Typically placing the black bolts at the 10 o’clock and 4 o’clock position.

Step 6: Check orientation of angle and nGauge for desired position.  Rotating the mount to the right angles nGauge towards the driver.  Rotating the mount to the left angles the nGauge downwards.  

Step 7: Once the ideal angle and position of gauge is found, carefully press the EBoost2 into the mount. Make sure to press at the angle the gauge sits in the mount to avoid breaking. 

Step 8: Tighten the two black bolts to secure the mount position.

Step 9: Feed all wiring and boost reference through dash and connect before reinstalling trim panel.

Step 10: Replace dash trim piece with installed EBoost2 and mount.  Enjoy!